|
Author
|
Subject: Re: Installing Gibson Catback?????
|
|
Dan |
Posted At 16:38:35 12/20/2000
I had mine done at a local muffler shop and it took about 30-40 minutes. I watched the guy do it every step of the way, and the only special tool I saw him use was a cutting torch on the old exhaust. With the old stuff out of the way, it bolted right up using the stock mounts. The hardest part seemed to be deciding exactly where to cut the old system so the "hump" on the new one would clear the rear axle. If I had been doing it myself, it probably would have taken considerably longer and involved at least one trip to the hospital. But that's just me.
|
| Erick |
Re: Installing Gibson Catback????? (Currently 0 replies)
Posted At 21:04:13 12/28/2000
I have a 93 dakota sport reg cab short bed. I installed
it my self it is not hard to install with a little help
from a friend. I cut the old exhaust where the tail
pipe comes out of the muffler with a electric saw.I cut
pipe at cat as directions in the cat back kit
ps follow the directions in the kit and you will be fine
it sounds good and has more power
I put it on a v6
|
| Erick |
Re: Installing Gibson Catback????? (Currently 0 replies)
Posted At 21:04:51 12/28/2000
I have a 93 dakota sport reg cab short bed. I installed
it my self it is not hard to install with a little help
from a friend. I cut the old exhaust where the tail
pipe comes out of the muffler with a electric saw.I cut
pipe at cat as directions in the cat back kit
ps follow the directions in the kit and you will be fine
it sounds good and has more power
I put it on a v6
|