|
|
 |
16:39:06 - 03/20/2010
Inline 4 Cylinder Dakotas
| From | Message |
2pnt5ltrluv
GenIII
 
2/20/2002
15:03:50
|
 Subject: RE: Problem ...
IP: Logged
Message:
Hehe, Lesley. I might be able to...hehe
Drive it like you stole it...
Flowmaster 40 series Delta, Bosch Platinum 4 plugs, 180 d thermostat, AIRAID intake w/K&N cone, Jet Chip stage 2 , Altezza tail lights, Billet Aluminum fuel door, 5% tint all around.
|
Dodge MiCK
GenIII
2/24/2002
08:19:21
| RE: Problem ...
IP: Logged
Message:
I agree w/ you about my tints, but I didn't have the $ at the time for him to go over the factory tint for the rear sliding window, so I tried to match it as best I can without it looking too much like limo-tint.
It was 28% in the back, and all he does it 35, 20, 15 and 5... I went with the lighter, and I'm happy!
Moving on, How did you debadge your truck? Did you sit it out in the Texas heat for a day and peel them off??
01 Sport 4x2 RC 3.9 3.55
Mods - IAT Adjuster, 3923's, 35% tint, Ractive CAI
Near Future Mods - 180 T'Stat, Clear Corners, TPS @ .75V
|
2pnt5ltrluv
GenIII
2/24/2002
10:13:08
| RE: Problem ...
IP: Logged
Message:
No!! I got a hairdryer and my fingernail and slowly peeled them off. I used my fingers cause there is less of a chance of scratching the paint. Then I used 3M Adhesive remover to remove the sticker goo. Viola! It took me about an hour to completely debadge. When you use the hair dryer, put it on a high setting and hold it about 2-3 inches (5-7 cm for you canucks...hehe) and hold in one spot for about 10 seconds. Use your fingernail and gently pick at a corner, when you get enough to grip, pull slowly. The sticker should peel off. Repeat until the stickers go bye-bye. After that, a few spurts of the remover and a good buffing...Ta-da!
Drive it like you stole it...
Flowmaster 40 series Delta, Bosch Platinum 4 plugs, 180 d thermostat, AIRAID intake w/K&N cone, Jet Chip stage 2 , Altezza tail lights, Billet Aluminum fuel door, 5% tint all around.
Coming Soon: Supercharger, New Throttle Body, MSD Ignition, and 1.7 Rockers.
|
Dodge MiCK
GenIII
2/24/2002
22:11:43
| RE: Problem ...
IP: Logged
Message:
I'm thinking of scratching them off w/ a quarter... hehe
01 Sport 4x2 RC 3.9 3.55
Mods - IAT Adjuster, 3923's, 35% tint, Ractive CAI
Near Future Mods - 180 T'Stat, Clear Corners, TPS @ .75V
|
2pnt5ltrluv
GenIII
2/24/2002
22:15:11
| RE: Problem ...
IP: Logged
Message:
How about using a rusty nail, or an old spoon...hehe
Drive it like you stole it...
Flowmaster 40 series Delta, Bosch Platinum 4 plugs, 180 d thermostat, AIRAID intake w/K&N cone, Jet Chip stage 2 , Altezza tail lights, Billet Aluminum fuel door, 5% tint all around.
Coming Soon: Turbocharger, New Throttle Body, MSD Ignition, and Nitrous.hehe
|
Knobbyman
*GenIII*
2/26/2002
08:43:17
| RE: Problem ...
IP: Logged
Message:
FYI.. Gas works to get the goo off also.
That's what I used to get the dealer badge off my truck. Just don't smoke while your doing it that'd be BAD!
'01 Graphite QC 4x4
4.7 3.55 LSD
http://www.knobbyman.com
----Speed only breaks stuff faster----
|
Geoff
GenIII
2/26/2002
10:36:26
| RE: Problem ...
IP: Logged
Message:
I used the 3M removal wheel only worked great
Geoff
2000 3.9L RC Sport. Flame Red. 5-speed, 3.55, Airaid, Vortex Muffler, F&B 48mm TB, 180 T-Stat, Autolite 3923s, IAT Adjuster, Clear Corners, SS Grill Insert, JBA Plug Wires, Underdrive Crank Pulley. Hurst Shifter, Removed Clutch Fan, Sony CDX-MP450X MP3, Infinity Reference Speakers
|
Lesley
GenIII
2/26/2002
10:56:39
| RE: Problem ...
IP: Logged
Message:
I used the non-acetone nail polish remover - $1.99 from Wal-Mart. And... just think - you have enough left over for your toes! :)
97 3.9 CC Sport. Black. Auto 3.55
Quick D Intake, JBA Stainless headers, Autolite 3923s, stainless Borla Turbo XL, V8 R/T TB,
19 lb.FMS fuel injectors. Coming 17" Boyd Coddington Smoothies
|
Dodge MiCK
GenIII
2/26/2002
13:02:00
| RE: Problem ...
IP: Logged
Message:
yeah, I do need to redo my toes...
01 Sport 4x2 RC 3.9 3.55
Mods - IAT Adjuster, 3923's, 35% tint, Ractive CAI
Near Future Mods - 180 T'Stat, Clear Corners, TPS @ .75V
|
Knobbyman
*GenIII*
2/26/2002
15:13:54
| RE: Problem ...
IP: Logged
Message:
I was thinking the same think Mick.
'01 Graphite QC 4x4
4.7 3.55 LSD
http://www.knobbyman.com
----Speed only breaks stuff faster----
|
Lesley
GenIII
2/26/2002
15:24:54
| RE: Problem ...
IP: Logged
Message:
Well, I wouldn't mind some pictures of that, it might help when I go to do my own :), c'mon Mick, I posted the clear corner pics for you!
97 3.9 CC Sport. Black. Auto 3.55
Quick D Intake, JBA Stainless headers, Autolite 3923s, stainless Borla Turbo XL, V8 R/T TB,
19 lb.FMS fuel injectors. Coming 17" Boyd Coddington Smoothies
|
Dodge MiCK
GenIII
2/26/2002
17:56:37
| RE: Problem ...
IP: Logged
Message:
LOL! Man those corners look sexy too!
Probably a lot better than my lime green toe nails!!
BTW, got my clears delivered and installed now.. took me 20 minutes to do the install... Man, really cleans up the front end a lot!
01 Sport 4x2 RC 3.9 3.55
Mods - IAT Adjuster, 3923's, 35% tint, Homebrew Ractive Intake, Clear Corners
Near Future Mods - 180 T'Stat, TPS @ .75V, V8 Throttle Body
|
Lesley
GenIII
2/26/2002
18:38:10
| RE: Problem ...
IP: Logged
Message:
You got them? That's great! They would look good on a truck your colour. I thought you would have posted a "Woohoo" they are finally here thread!!!
97 3.9 CC Sport. Black. Auto 3.55
Quick D Intake, JBA Stainless headers, Autolite 3923s, stainless Borla Turbo XL, V8 R/T TB,
19 lb.FMS fuel injectors. Coming 17" Boyd Coddington Smoothies
|
Dodge MiCK
GenIII
2/26/2002
19:28:51
| RE: Problem ...
IP: Logged
Message:
I'm not the impatient type!! :)
01 Sport 4x2 RC 3.9 3.55
Mods - IAT Adjuster, 3923's, 35% tint, Homebrew Ractive Intake, Clear Corners
Near Future Mods - 180 T'Stat, TPS @ .75V, V8 Throttle Body
|
| | <<Oringinal Post <<Previous Page P 2 |
|
Post a reply to this message:
Username Registration: Required
Posting: Registered Users and Administrators only
|
|
