Forums
Forum Tools
|
 |
13:30:25 - 05/31/2024
General Dakota Board
| From | Message |
jmaas
Dodge Dakota
JOIN HERE
1/28/2005
10:06:11
|
 Subject: R&R of EGR Valve
IP: Logged
Message:
I have a 94 Dakota, and I am getting ready to replace the EGR Valve.Is there any thing spiecal that I need to be aware of ie; broken bolts.
Any tips or tricks on how to remove it would be greatly appreciated.
|
Sneezer
Dodge Dakota
JOIN HERE
1/28/2005
11:36:08
|  RE: R&R of EGR Valve
IP: Logged
Message:
On my 92 it was not very difficult. It is a little tight in the back of the engine. It is only 2 bolts, an electrical connection and I think a vacuum hose as well. Hardest part is snaking everything back in because you have some vacuum lines, plug wires and fuel all in the same spot, and it is right next to the distributor.
|
bob70
Dodge Dakota
JOIN HERE
2/07/2005
20:08:32
| RE: R&R of EGR Valve
IP: Logged
Message:
Hi, I have a 94 5.2 and just changed mine today, it is not a rough job, like sneezer said, the biggest pain is getting it in and out through all the wires and hoses. And when I put the new one in, I put the gasket on the bottom of the egr and held it on with the bolts, made it a little easier to line everything up, then I started to tighten the bolts, and then pushed the egr down so it was flush with the engine(I mention this because if you tighhten the bolts down before the egr is flush, they will feel tight but the valve will be loose) good luck
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
